Asynchronous Early Output Dual-Bit Full Adders Based on Homogeneous and Heterogeneous Delay-Insensitive Data Encoding

This paper presents the designs of asynchronous early output dual-bit full adders without and with redundant logic (implicit) corresponding to homogeneous and heterogeneous delay-insensitive data encoding. For homogeneous delay-insensitive data encoding only dual-rail i.e. 1-of-2 code is used, and for heterogeneous delay-insensitive data encoding 1-of-2 and 1-of-4 codes are used. The 4-phase return-to-zero protocol is used for handshaking. To demonstrate the merits of the proposed dual-bit full adder designs, 32-bit ripple carry adders (RCAs) are constructed comprising dual-bit full adders. The proposed dual-bit full adders based 32-bit RCAs incorporating redundant logic feature reduced latency and area compared to their non-redundant counterparts with no accompanying power penalty. In comparison with the weakly indicating 32-bit RCA constructed using homogeneously encoded dual-bit full adders containing redundant logic, the early output 32-bit RCA comprising the proposed homogeneously encoded dual-bit full adders with redundant logic reports corresponding reductions in latency and area by 22.2% and 15.1% with no associated power penalty. On the other hand, the early output 32-bit RCA constructed using the proposed heterogeneously encoded dual-bit full adder which incorporates redundant logic reports respective decreases in latency and area than the weakly indicating 32-bit RCA that consists of heterogeneously encoded dual-bit full adders with redundant logic by 21.5% and 21.3% with nil power overhead. The simulation results obtained are based on a 32/28nm CMOS process technology

Latency Optimized Asynchronous Early Output Ripple Carry Adder based on Delay-Insensitive Dual-Rail Data Encoding

Asynchronous circuits employing delay-insensitive codes for data representation i.e. encoding and following a 4-phase return-to-zero protocol for handshaking are generally robust. Depending upon whether a single delay-insensitive code or multiple delay-insensitive code(s) are used for data encoding, the encoding scheme is called homogeneous or heterogeneous delay-insensitive data encoding. This article proposes a new latency optimized early output asynchronous ripple carry adder (RCA) that utilizes single-bit asynchronous full adders (SAFAs) and dual-bit asynchronous full adders (DAFAs) which incorporate redundant logic and are based on the delay-insensitive dual-rail code i.e. homogeneous data encoding, and follow a 4-phase return-to-zero handshaking. Amongst various RCA, carry lookahead adder (CLA), and carry select adder (CSLA) designs, which are based on homogeneous or heterogeneous delay-insensitive data encodings which correspond to the weak-indication or the early output timing model, the proposed early output asynchronous RCA that incorporates SAFAs and DAFAs with redundant logic is found to result in reduced latency for a dual-operand addition operation. In particular, for a 32-bit asynchronous RCA, utilizing 15 stages of DAFAs and 2 stages of SAFAs leads to reduced latency. The theoretical worst-case latencies of the different asynchronous adders were calculated by taking into account the typical gate delays of a 32/28nm CMOS digital cell library, and a comparison is made with their practical worst-case latencies estimated. The theoretical and practical worst-case latencies show a close correlation....Comment: arXiv admin note: text overlap with arXiv:1704.0761

Estimation of biomass density and carbon storage in the forests of Andhra Pradesh, India, with emphasis on their deforestation and degradation conditions

The current study evaluates the growing stock, biomass and carbon content of Andhra Pradesh state’s forest (India) along with its current status of forest degradation and loss. For this purpose, the study used the growing stock data collected by state forest department in 2010 for the calculation of biomass and carbon storage using the standard conversion and expansion factors given by IPCC. The analysis shows low biomass and carbon values for the state’s forest in comparison to the mean values recorded in different studies made for Andhra Pradesh. It is also observed to be lower when compared with the average carbon and biomass for Indian forests. Overall, the analysis showed degradation and loss of forest in the state, coupled with reduction in biomass and carbon sink

Source Regions of Coronal Mass Ejections

Observations of the solar corona with the Large Angle Spectrometric Coronograph (LASCO) and Extreme ultraviolet Imaging Telescope (EIT) instruments on the Solar and Heliospheric Observatory (SOHO) provide an unprecedented opportunity to study coronal mass ejections (CMEs) from their initiation through their evolution out to 30 \rsun. The objective of this study is to gain an understanding of the source regions from which the CMEs emanate. To this end, we have developed a list of 32 CMEs whose source regions are located on the solar disk and are well observed in EIT 195 {\AA} data during the period from so lar minimum in January 1996 through the rising part of the cycle in May 1998. We compare the EIT source regions with photospheric magnetograms from the Michelson Doppler Imager (MDI) instrument on SOHO and the NSO/Kitt Peak Observatory and also with H$\alpha$ data from various sources. The overall results of our study show that 41% of the CME related transients observed are associated with active regions and have no prominence eruptions, 44% are associated with eruptions of prominences embedded in active regions and 15% are associated with eruptions of prominences outside active regions. Those CMEs that do not involve prominence eruptions originate in active regions both with and without prominences. We describe 6 especially well observed events. These case studies suggest that active region CMEs (without eruptive prominences) are associated with active regions with lifetimes between 11--80 days. They are also often associated with small scale emerging or cancelling flux over timescales of 6--7 hours. CMEs associated with active region prominence eruptions, on the other hand, are typically associated with old active regions with lifetimes $\sim$ 6-7 months.Comment: Accepted for publication in ApJ, scheduled for Nov 1, 2001 issu